Knock Sensor: Service and Repair

Knock Sensor

REMOVAL
1. Disconnect the ground cable from the battery.






2. Remove the intercooler.
3. Disconnect the knock sensor connector.






4. Remove the knock sensor from the cylinder block.






INSTALLATION
1. Install the knock sensor to the cylinder block.

NOTE: The portion of the knock sensor cord that is pulled out must be positioned at a 60° angle relative to the engine rear.

Tightening Torque: 24N.m (2.4kgf.m, 17.7 ft-lb)






2. Connect the knock sensor connector.






3. Install the intercooler.
4. Connect the ground cable to the battery.