> display screen, select the {Each System Check}.
2. On the <> display screen, select the {Engine Control System}.
3. Click the [OK] button after the information of engine type has been displayed.
4. On the <> display screen, select the {Clear Memory}.
5. When the <> is shown on the screen, click the [Yes] button.
6. When <> and <ignition switch to OFF>> is shown on the display screen, turn the ignition switch to OFF.

NOTE:
- Initial diagnosis of electronic throttle control is performed after memory clearance. For this reason, start the engine after 10 seconds or more have elapsed since the ignition switch was turned to ON.
- For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".

2. SUBARU SELECT MONITOR (OBD MODE)
1. On the <

> display screen, select the {Each System Check}.
2. On the <> display screen, select the {Engine Control System}.
3. Click the [OK] button after the information of engine type has been displayed.
4. On the <> display screen, select the {OBD System}.
5. On the <> display screen, select the {Clear Diagnostic Code?}.
6. When the <> is shown on the screen, click the [Yes] button.
7. When <> and <ignition switch to OFF>> is shown on the display screen, turn the ignition switch to OFF.

NOTE:
- Initial diagnosis of electronic throttle control is performed after memory clearance. For this reason, start the engine after 10 seconds or more have elapsed since the ignition switch was turned to ON.
- For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".