DTC - General Descriptions

DTC P0600 SERIAL COMMUNICATION LINK

1. OUTLINE OF DIAGNOSIS
Detect malfunction of CAN communication.
Judge as NG if CAN communication is not available.

2. COMPONENT DESCRIPTION
ECM, VDC CM and DCCD CM are connected by high speed CAN.

(Common Specifications)
CAN Protocol 2.0 B (Active)
Frame Format: 11 Bit ID Frame (Standard Frame)

(High speed CAN)
Conforms to ISO11898
Communication Speed: 500 kbps

3. ENABLE CONDITIONS






4. GENERAL DRIVING CYCLE
Perform the diagnosis continuously after starting the engine.

5. DIAGNOSTIC METHOD

- Abnormality Judgment
Judge as NG when the following conditions are established.

Judgment Value






Time Needed for Diagnosis: Less than 1 second
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.

- Normality Judgment
Judge as OK and clear the NG if the continuous time while the following conditions are established is more than the predetermined time.

Judgment Value






Time Needed for Diagnosis: 1000 ms
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.

6. DTC CLEAR CONDITION
- When the OK idling cycle is completed 40 times in a row
- When "Clear Memory" is performed

7. MALFUNCTION INDICATOR LIGHT CLEAR CONDITIONS
- When the OK driving cycle is completed 3 times in a row
- When "Clear Memory" is performed

8. FAIL SAFE
Accelerator pedal position sensor request target throttle opening angle calculation: AT protecting torque guard is usually obtained by CAN communication. It is specified as 408 N.m (42 kgf.m, 301 ft.lb).

9. ECM OPERATION AT DTC SETTING
Memorize the freeze frame data. (For test mode $02)