Symptom Related Diagnostic Procedures

Security System

INSPECTION

1. BASIC DIAGNOSTIC PROCEDURE

Step 1-6:

Step 7-11:

NOTE: Check the function settings of the body integrated unit if any of the following symptoms appear.
- The horn does not sound even when the security alarm is triggered and operating. As a cause, it is possible that the siren ON/OFF setting is set to ON in the customization function.
- The horn sounds when setting the security to ON (Monitoring condition) using the keyless transmitter. As a cause, it is possible that the impact sensor present (ON) / not present (OFF) setting is set to ON in the customization function though there is no impact sensor.

2. CHECK SECURITY SYSTEM CONDITION MEMORY
1. Pull out the key from the ignition switch, or turn the ignition to OFF.
2. Close all the doors and the rear gate.
3. Open the front hood.
4. Press the LOCK button of the keyless transmitter.

NOTE: Wait until the security indicator light blinks twice within 0.5 seconds at 2 second intervals. If the 30 second monitoring lag has been set, wait 30 seconds.

5. Disconnect the ground cable from the battery.
6. Connect the ground cable to the battery.
7. Check that the security indicator light blinks twice within 0.5 seconds at 2 second intervals. When it does not blink, replace the body integrated unit.

3. SECURITY SYSTEM ON/OFF SETTING
1. Close all doors and rear gate, and sit in the driver's seat. Press the UNLOCK button of the keyless transmitter.
2. Turn the ignition switch to ON.
3. Push the centralized door lock switch down and open the driver's side door at the same time, and hold in this condition for 10 seconds.
4. If the security system is ON, it will turn OFF. If OFF, it will turn ON.

4. CHECK DOOR SWITCH