Procedures

REAR GATE

DISPOSAL

REAR GATE DAMPER STAY

CAUTION: Gas is colorless, odorless, and harmless. However, gas pressure may spray cutting powder or oil. Be sure to wear dust-resistant goggles.

1. Cover with a vinyl sack as shown in the figure.






NOTE: Prevent the vinyl sack from being caught by drill cutting edge.

2. Lift the body side slightly with piston rods fully extended, and secure the body side with vise.
Drill a hole of 2 to 3 mm (0.08 to 0.12 in) diameter at a point 10 to 200 mm (0.39 to 7.87 in) from the body side, and bleed the gas in the rear gate damper stay completely.