Upper Inner Trim

UPPER INNER TRIM

REMOVAL

1. Remove the cap (A) on the upper side of the pillar trim, and remove the bolt inside.
2. Remove the front pillar upper trim.






3. Remove the front inside scuff plate, rear inside scuff plate and center pillar lower trim.
4. Remove anchor bolt (A).
5. Loosen the shoulder anchor bolt (B), and then detach the shoulder anchor from center pillar.

6. Remove the cap (A) on the upper side of the pillar trim, and remove the bolt inside.
7. Remove the weatherstrip (B).
8. Remove the upper trim clip of the center pillar along with lower trim, pull it straight out.

9. Pull the upper trim and then remove the lower trim claw while expanding it.

INSTALLATION

Install in the reverse order of removal.

Tightening torque 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)