Radiator Sub Fan and Fan Motor

Radiator Sub Fan and Fan Motor

REMOVAL

1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.





3) Lift up the vehicle.
4) Remove the under cover.
5) Disconnect the sub fan motor connector (B).





6) Lower the vehicle.
7) Remove the air intake duct.
8) Remove the mounting bolts from the radiator sub fan motor assembly and over flow pipe.





9) Raise the radiator sub fan motor assembly slightly, lift the pin on the lower side of the radiator sub fan monitor assembly from the radiator hole, and remove the sub fan from underneath the vehicle.

INSTALLATION

Install in the reverse order of removal.

NOTE: Check that the radiator hose and over flow hose are connected properly.

Tightening torque: 7.5 Nm (0.8 kgf-m, 5.5 ft. lbs.)





DISASSEMBLY

1) Remove the clip holding the sub fan motor connector on the radiator sub fan shroud.
2) Remove the nuts holding the radiator sub fan to the sub fan motor.





3) Remove the bolts holding the sub fan motor to the radiator sub fan shroud.





ASSEMBLY

Assemble in the reverse order of disassembly.
Tightening torque: 4.41 Nm (0.45 kgf-m, 3.25 ft. lbs.)





Tightening torque: 3.4 Nm (0.3 kgf-m, 2.5 ft. lbs.)