MT Gear Shift Lever
MT Gear Shift LeverREMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.
3) Remove the gear shift knob.
4) Remove the console box front.
5) Remove the clamp.
6) Remove the boot and insulator assembly.
7) Remove the harness clamp from the plate assembly.
8) Remove the plate assembly from the body.
9) Lift up the vehicle.
10) Remove the under cover.
11) Remove the rear exhaust pipe and muffler.
12) Remove the heat shield cover.
13) Remove the crossmember.
14) Remove the snap pin and washer, and remove the reverse check cable from the reverse check lever.
15) Move the transmission to the right side, and remove the joint COMPL, stay bolts and reverse check cable.
NOTE: If the transmission is not moved aside, the joint COMPL and stay bolts may contact the body and cause damage.
16) Remove the cushion rubber from the body.
17) Lower the vehicle.
18) Remove the gear shift lever.
INSTALLATION
1) Insert the gear shift lever from the vehicle interior.
NOTE: Insert the rod and the stay, and position the lever on top of the transmission mount.
2) Mount the cushion rubber on the body.
Tightening torque: 18 N-m (1.8 kgf-m, 13.3 ft-lb)
3) Move the transmission to the right side of the vehicle, and install the joint COMPL and stay.
Tightening torque:
T1: 12 N-m (1.2 kgf-m, 8.9 ft-lb)
T2: 32 N-m (3.3 kgf-m, 23.6 ft-lb)
4) Install the crossmember.
5) Install the reverse check cable end, washer and snap pin to the reverse check lever.
NOTE:
^ Be careful to install the snap pin in the proper direction.
^ Adjust the reverse check cable before installation.
6) Install the heat shield cover.
7) Install the rear exhaust pipe and muffler.
8) Install the under cover.
9) Install the boot plate.
NOTE: Be careful not to twist the inner boot when installing.
Tightening torque: 18 N-m (1.8 kgf-m, 13.3 ft-lb)
(1) Set the plate assembly to the vehicle.
(2) Temporarily tighten the bolt (A).
(3) Tighten the bolt (B).
(4) Tighten the bolt (A).
(5) Tighten the bolts (C) and (D).
10) Install the harness clamp to the plate assembly.
11) Install the boot and insulator assembly, and secure with a clamp.
12) Install the console box front.
13) Check whether the gear shift shifts into each gear position.