Clearing Diagnostic Trouble Codes
CLEAR MEMORY MODE1) Place the change lever in neutral.
2) On the [[Main Menu]] display screen, select (Each System Check}.
3) On the [[System Selection Menu]] display screen, select (Transmission Control System}.
4) After the (Center Differential Control}. is displayed, select [OK].
5) On the [[Transmission Diagnosis]] display screen, select (Clear Memory}.
6) When the [[Done. Turn ignition switch OFF]] is displayed, select [OK].
7) Turn the Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.
NOTE:
^ To clear the previous DTC, use (Clear Memory).
^ For details concerning the operation procedure, refer to the "PC Application Help for Subaru Select Monitor".