Reading Diagnostic Trouble Codes
Subaru Select MonitorOPERATION
READ DIAGNOSTIC TROUBLE CODE (DTC)
1) Prepare the Subaru Select Monitor kit.
2) Prepare the personal computer which has been installed the Subaru Select Monitor.
3) Connect the US13 cable between SDI (Subaru Diagnosis Interface) and US13 port on the personal computer (dedicated port for the Subaru Select Monitor).
NOTE: The port for Subaru Select Monitor is the US13 port used for installing the Subaru Select Monitor.
4) Connect the diagnosis cable to SDI.
5) Connect the SDI to data link connector located in the lower portion of the instrument panel (on the drivers side).
CAUTION: Do not connect the scan tools other than the Subaru Select Monitor.
6) Start a PC.
7) Turn the ignition switch to ON.
8) Run the "PC application help for Subaru Select Monitor".
9) On the [[Main Menu]] display screen, select (Each System Check}.
10) On the [[System Selection Menu]] display screen, select (Transmission Control System}.
11) After the (Center Differential Control}. is displayed, select [OK].
12) On the [[Transmission Diagnosis]], select (Diagnostic Code(s) Display}.
13) On the [[Diagnostic Code(s) Display]], select (Temporary Diagnostic Code(s)} or (Memorized Diagnostic Code(s)}
READ CURRENT DATA
1) On the [[Main Menu]] display screen, select (Each System Check}.
2) On the [[System Selection Menu]] display screen, select (Transmission Control System}.
3) After the (Center Differential Control}. is displayed, select [OK].
4) Select (Current Data Display & Save} in the [[Transmission Diagnosis]] screen.
5) On the [[Current Data Display & Save]], select (Normal sampling}.
6) Using the scroll key, scroll the display screen up or down until the desired data is shown.
^ A list of the support data is shown in the following table.
NOTE: For details concerning the operation procedure, refer to the "PC Application Help for Subaru Select Monitor".