Clear Memory Mode

Clear Memory Mode

OPERATION

1. ECM
1. On the [[Main Menu]], select {Each System Check}.
2. On the [[System Selection Menu]], select {Engine}.
3. After engine type information is displayed, select [OK].
4. On the [[Engine Diagnosis]], select {Clear Memory}.
5. When Done is displayed on the display screen, end the Subaru Select Monitor and turn the ignition switch to OFF.

NOTE:
- After the memory has been cleared, the idle air control solenoid valve must be initialized. To execute this procedure, turn the ignition switch to ON. Wait 3 seconds before starting the engine.
- For detailed operation procedure, refer to the "help on PC application for Subaru Select Monitor".

2. BODY INTEGRATED UNIT
1. On the [[Main Menu]], select {Each System Check}.
2. On the [[System Selection Menu]], select {Integrated Unit}.
3. After {Integrated Unit} is displayed, select [OK].
4. On the [[Integ. Unit mode]], select {Clear Memory}.
5. When Done is displayed on the display screen, end the Subaru Select Monitor and turn the ignition switch to OFF.

NOTE: For detailed operation procedure, refer to the "help on PC application for Subaru Select Monitor".