Fluid Filter - A/T: Service and Repair
ATF FilterREMOVAL
NOTE: The ATF filter is maintenance free.
1) Disconnect the battery ground cable and remove the battery from the vehicle.
2) Remove the harness securing bracket.
3) Using the ST, remove the ATF filter.
ST 498545400 OIL FILTER WRENCH
INSTALLATION
1) Apply a thin coat of ATF to the oil seal part of new ATF filter.
2) Install the ATF filter. Turn it by hand, being careful not to damage oil seal.
3) Tighten the ATF filter using ST.
Calculate the ATF filter tightening torque using following formula.
T2 = L2/(L1 + L2) x T1
T1: 14 N-m (1.4 kgf-m, 10.1 ft-lb)
[Required torque setting]
T2: Tightening torque
L1: ST length 78 mm (3.07 in)
L2: Torque wrench length
Example:
NOTE: Align the ST with the torque wrench while tightening the ATF filter.
ST 498545400 OIL FILTER WRENCH
4) Fill ATF.
5) Inspect the level of ATF.
6) Install the harness securing bracket.
7) Install the battery.
INSPECTION
Check for rust, hole, ATF leaks or other damage. Replace the part if any damage is found in the inspection.