Fuel Sub Level Sensor

Fuel Sub Level Sensor

REMOVAL

WARNING: Place "NO OPEN FLAMES" signs near the working area.

CAUTION:
- Be careful not to spill fuel.
- Prior to start work, be sure to set the fuel volume to three-forth full of the fuel tank. If the fuel is more than three-forth full of the fuel tank, be careful because the fuel may spill out.

1. Drain fuel.
2. Remove the rear seat.
3. Remove the service hole cover.
1. Remove bolt (A).
2. Push the grommet (B) down and remove the service hole cover.






4. Disconnect the connector from the fuel sub level sensor.






5. Disconnect the quick connector, then disconnect the fuel delivery hose and jet pump hose.
6. Remove the nuts and bolts which install fuel sub level sensor on fuel tank.






7. Remove the fuel sub level sensor.

INSTALLATION
Install in the reverse order of removal.

NOTE:
- Use a new gasket.
- Make sure the sealing portion is free from fuel or foreign matter before installation.
- Align protrusion (A) of the gasket to the position shown in the following figure.
- Align protrusion (B) of the fuel sub level sensor to the cut out in the fuel sublevel sensor upper plate.
- Tighten the nuts and bolts to the specified torque in the order as shown in the figure.