Gear Sensor/Switch: Service and Repair

REMOVAL

BACK-UP LIGHT SWITCH & NEUTRAL POSITION SWITCH
1) Disconnect the ground cable from battery.
2) Remove the air intake chamber and intake boot. (Non-turbo model)
3) Remove the intercooler. (Turbo model)
4) Disconnect the connector back-up light switch & neutral position switch.
^ Non-turbo model





^ Turbo model





5) Lift up the vehicle.
6) Remove the back-up light switch & neutral position switch with the harness.





INSTALLATION

BACK-UP LIGHT SWITCH & NEUTRAL POSITION SWITCH
1) Install the back-up light switch & neutral position switch with the harness.





2) Connect the connectors of back-up light switch & neutral position switch.
3) Install the air intake chamber and intake boot. (Non-turbo model)
4) Install the intercooler. (Turbo model)
5) Connect the battery ground cable to the battery.

INSPECTION

BACK-UP LIGHT SWITCH
Check the back-up light switch.
NEUTRAL POSITION SWITCH
1) Turn the ignition switch to OFF.
2) Disconnect the connector of neutral position switch.
3) Measure the resistance between neutral position switch terminals.
^ Non-turbo model





^ Turbo model





4) Replace faulty parts.