Transfer Driven Gear
Transfer Driven GearREMOVAL
1) Remove the manual transmission assembly from the vehicle.
2) Remove the back-up light switch & neutral position switch.
3) Remove the transfer case together with the extension case assembly.
4) Remove the extension case assembly.
5) Remove the transfer driven gear.
6) Remove bearing outer races from the extension case and transfer case.
INSTALLATION
1) Install the bearing outer races to extension case and transfer case.
2) Install the transfer driven gear.
3) Install the transfer case and the extension case assembly.
4) Install the back-up light switch and the neutral position switch.
5) Install the manual transmission assembly to the vehicle.
DISASSEMBLY
1) Using the ST, remove the roller bearing (extension case side).
ST 498077000 REMOVER
2) Using ST1 and ST2, remove the roller bearing (transfer case side).
ST1 498077000 REMOVER
ST2 899864100 REMOVER
ASSEMBLY
1) Using the ST, install the roller bearing (extension case side).
ST1 398177700 INSTALLER
ST2 899864100 REMOVER
CAUTION: Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
2) Using ST, install the roller bearing (transfer case side).
ST 499757002 INSTALLER
CAUTION: Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
INSPECTION
1) Bearing
Replace the bearings in the following cases.
^ In case of broken or rusty bearings
^ In case of worn or damaged bearings
^ When the bearings fail to turn smoothly or emit noise in rotation after gear oil lubrication.
2) Driven gear
If the driven gear tooth surface and shaft are excessively broken or damaged, replace the driven gear.