Clearing Diagnostic Trouble Codes
CLEAR MEMORY MODE1) Check that the select lever is in "P" range.
2) On the �Main Menu�, select {Each System Check}.
3) On the �System Selection Menu�, select {Transmission}.
4) After transmission type information pops up, select [OK].
5) On the �Transmission Diagnosis�, select {Clear Memory}.
6) When the "Done. Turn ignition switch to OFF" pops up, select [OK].
7) Turn Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.
NOTE:
^ If {Clear Memory 2} is selected and performed, DTC and learned control memory are cleared. If {Clear Memory 2} is performed, perform learning control promotion.
^ For details concerning the operation procedure, refer to the "help on PC application for Subaru Select Monitor".