Front Crossmember Support Plate
Front Crossmember Support PlateREMOVAL
1) Lift up the vehicle.
2) Remove the front under cover.
3) Remove the bolt and remove front crossmember support plate.
^ Large type
^ Small type
INSTALLATION
Install in the reverse order of removal.
NOTE: Tighten the small type crossmember support plate together with stabilizer bracket.
After installing the stabilizer bracket to the cross-member, tighten the crossmember support plate together.
Tightening torque:
Crossmember support plate: 60 N-m (6.1 kgf-m, 44.3 ft-lb)
Crossmember support plate (Tightened together with the stabilizer bracket): 25 N-m (2.5 kgf-m, 18.1 ft-lb)
Jack-up plate: 60 N-m (6.1 kgf-m, 44.3 ft-lb)