Radiator Sub Fan and Fan Motor
Radiator Sub Fan and Fan MotorREMOVAL
1) Set the vehicle on a lift.
2) Remove the collector cover.
3) Disconnect the ground cable from the battery.
4) Remove the hood stay holder.
5) Remove the air intake duct.
6) Disconnect the connector from radiator fan control unit.
7) Remove the bolts which hold the sub shroud to the radiator.
8) Lift up the vehicle.
9) Remove the under cover.
10) Remove the radiator sub fan shroud through the under side of vehicle.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 7.5 N-m (0.76 kgf-m, 5.5 ft-lb)
DISASSEMBLY
1) Remove the nut which holds fan to fan motor and shroud assembly.
2) Remove the clip which holds the fan motor onto the shroud.
3) Remove the bolts which hold the radiator fan control unit to the shroud.
ASSEMBLY
Assemble in the reverse order of disassembly.
Radiator fan control unit bolt: Tightening torque: 5.4 N-m (0.55 kgf-m, 4.0 ft-lb)
Tightening torque: 3.8 N-m (0.39 kgf-m, 2.8 ft-lb)
Tightening torque: 6.2 N-m (0.63 kgf-m, 4.6 ft-lb)
INSPECTION
1) Disconnect the connector from radiator fan control unit.
NOTE: Do not remove the main fan motor harness connector.
2) Connect the battery to radiator fan control unit as shown in the figure.
3) Check the fan motor for operations. If it does not operate, check the fan motor.