Removal and Replacement

Combination Meter

REMOVAL
1. Disconnect the ground cable from the battery.
2. Set the tilt steering at the lowest position.
3. Remove the instrument panel lower cover.
4. Remove the screws of the combination meter (one on the upper side, two on lower side) and pull while tilting the meter towards yourself.






5. Disconnect the connector in the rear side of combination meter to remove meter.

CAUTION:
- Be careful not to damage the meter or instrument panel.
- Pay particular attention to avoid damaging the meter glass.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Make sure the electrical connector is connected securely.
- Make sure that each meter operates normally.
- When the combination meter of model with immobilizer has been replaced, be sure to perform the registration of immobilizer.