Rear Arm

DISASSEMBLY

FRONT BUSHING
1) Set the ST A with the larger side of its inner diameter turned upward.
2) Set the rear arm with the protruding side of bushing turned upward.
3) Place the ST B on bushing, and push the bushing out.
ST A 20099AE020INSTALLER & REMOVER SET
ST B 20099AE020INSTALLER & REMOVER SET





REAR BUSHING
Using the ST C and bearing puller, press the rear bushing out.
ST C 20099AE040INSTALLER & REMOVER SET





ASSEMBLY

FRONT BUSHING
1) Set the ST A with the larger side of its inner diameter turned upward.
2) Set the rear arm with the vehicle inner side of arm turned downward.
3) Place the bushing on rear arm as shown in the figure.
4) Place the ST B on the bushing, and press-fit until each edge surface of bushing and rear arm is aligned.
ST A 20099AE020 INSTALLER & REMOVER SET
ST B 20099AE020INSTALLER & REMOVER SET





REAR BUSHING
1) Insert the bushing into the bore of ST D.
2) Set the ST C, ST D and bearing puller in the specified positions as shown in the figure, and then press-fit the bushing until the outer end of bushing and rear end of rear arm is flat.
ST C 20099AE040INSTALLER & REMOVER SET
ST D 20099AE040INSTALLER & REMOVER SET





INSPECTION
Check the rear arm for bending, corrosion or damage.