Rear Combination Light Assembly

Rear Combination Light Assembly

REMOVAL
1. SEDAN MODEL
1. Disconnect the ground cable from battery.
2. Remove the trunk room side trim.
3. Remove the four nuts, and then detach the rear combination light after disconnecting the connector.






2. WAGON MODEL
1. Disconnect the ground cable from battery.
2. Remove the clip.






3. While pressing the section (A), insert your finger or a flat-tip screwdriver wrapped with tape into the clearance (B) to remove claws in the order of (C), (D), (E), and remove the rear combination cover.






4. Remove the two bolts, and then detach the rear combination light by pulling it to the rear side of vehicle.






5. After turning the sockets of the tail/stop light bulbs and rear turn signal light bulbs, remove the rear combination light.

INSTALLATION
Install in the reverse order of removal.