Rear Hub Unit Bearing
Rear Hub Unit BearingREMOVAL
1) Disconnect the ground cable from the battery.
2) Lift up the vehicle, then remove the rear wheels.
3) Lift the crimped section of axle nut.
4) While applying the parking brake, remove the axle nut using a socket wrench.
CAUTION: Remove the wheel before loosening the axle nut. Failure to follow this rule may damage the wheel bearings.
5) Release the parking brake.
6) Remove the rear ABS wheel speed sensor.
7) Remove the disc brake caliper from back plate, and suspend it from the stabilizer using a wire.
8) Remove the disc rotor from the hub.
NOTE:
^ Mark the mating surface of hub and disc rotor before removing the disc rotor to avoid confusing when installing.
^ If it is difficult to remove the disc rotor from the hub, drive the 8 mm bolt into the threaded end of rotor, and then remove the rotor.
9) Remove the four bolts from rear arm.
10) Remove the hub unit bearing.
CAUTION:
^ Be careful not to damage the magnetic encoder.
^ Do not get closer the tool which charged magnetism to magnetic encoder.
NOTE: If it is hard to remove, use the ST.
ST1 926470000 AXLE SHAFT PULLER
ST2 28099PA110 AXLE SHAFT PULLER PLATE
INSTALLATION
1) Aligning the hub unit bearing to the mounting hole of the back plate, install the hub unit assembly and back plate. Tighten the axle nut temporarily.
CAUTION:
^ Be careful not to damage the magnetic encoder.
^ Do not get closer the tool which charged magnetism to magnetic encoder.
2) Tighten the four bolts.
Tightening torque: 65 N-m (6.6 kgf-m, 47.9 ft-lb)
3) Remove the axle nut.
4) Draw the rear drive shaft into specified position
5) Tighten the new axle nut temporarily.
CAUTION: Use a new axle nut (olive color).
6) Install the disc rotor to hub.
7) Install the disc brake caliper on the back plate.
Tightening torque: 66 N-m (6.7 kgf-m, 48.7 ft-lb)
8) Install the rear ABS wheel speed sensor and brake cable bracket.
9) Adjust the parking brake lever stroke by turning the adjuster.
10) While applying the parking brake and depressing the brake pedal, tighten a new axle nut to the specified torque and lock it securely.
Tightening torque: 240 N-m (24.5 kgf-m, 177 ft-lb)
CAUTION:
^ Install the wheel after installation of axle nut. Failure to follow this rule may damage the wheel bearing.
^ Be sure to tighten the axle nut to specified torque. Do not overtighten it as this may damage the wheel bearing.
11) After tightening the axle nut, lock it securely.
12) Install the wheel and tighten the wheel nuts to specified torque.
Tightening torque: 120 N-m (12.2 kgf-m, 88.5 ft-lb)