Keyless Entry Transmitter Battery: Service and Repair
TransmitterREMOVAL
1. TRANSMITTER BATTERY
Remove the battery (1) from the transmitter.
NOTE: To prevent static electricity damage to the transmitter printed circuit board, touch the steel area of building with hand to discharge static electricity carried on body or clothes before disassembling the transmitter.
INSTALLATION
1. TRANSMITTER BATTERY
Install in the reverse order of removal.
REPLACEMENT
1. REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITOR
NOTE:
- A maximum of four keyless transmitter can be registered for each individual vehicle.
- When replacing or adding the keyless transmitter, new registration of transmitter is necessary.
1. Connect the Subaru Select Monitor to the vehicle.
2. Turn the ignition switch to ON.
3. From the "System Selection Menu" of the Subaru Select Monitor, select {2. Check individual system} --> {7. Integ. unit mode} --> {8. Keyless transmitter ID registration}.
4. Input the 8-digit ID number attached to the plastic bag of the keyless transmitter or inside the transmitter, from left to right, then press the [Enter] key.
NOTE: Press the [] key on the Subaru Select Monitor to increase the number, and the [] key to decrease. Press the [<] key to move to the digit in the left, and [>] to the right.
5. The ID number you have entered will be shown. Make sure that the ID number shown is the same as that of plastic bag or inside of transmitter.
6. Press the [OK] key if the ID number is correct. If the ID number is incorrect, select [NO] to return to the step 3) and reenter the ID number.
7. �ID registration in process....� is displayed and registration starts.
8. �ID registration done� will be displayed when the registration process is done.
9. To exit, select �END: NO� to return to {8. Keyless transmitter ID registration}. If there are additional keyless transmitters to be registered, select �Next registration: OK� to return to the step 4).
NOTE:
- If the registration fails, �ID registration failed. Try again.� will be displayed. Select the [OK] key to return to the {8. Keyless transmitter ID registration}. And retry from the step 3).
- �END: NO� is shown on the Subaru Select Monitor when fourth keyless transmitter has been registered. Select the [NO] key to return to {8. Keyless transmitter ID registration}.