Reading Diagnostic Trouble Codes
Subaru Select MonitorOPERATION
READ DIAGNOSTIC TROUBLE CODE (DTC)
1) Prepare the Subaru Select Monitor kit.
2) Prepare PC with Subaru Select Monitor installed.
3) Connect the SDI (Subaru Diagnostic Interface) to the PC USB port (exclusively for Subaru Selector Monitor) using a USB cable.
NOTE:
Port exclusively for Subaru Select Monitor refers to the USB port used when installing Subaru Select Monitor.
4) Connect the diagnosis cable to the SDI.
5) Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION:
Do not connect scan tools other than the Subaru Select Monitor.
6) Start the PC.
7) Turn the ignition switch to ON.
8) Run the "PC application for Subaru Select Monitor".
9) On the [[Main Menu]], select {Each System Check}.
10) On the [[System Selection Menu]], select {Transmission}.
11) After transmission type information pops up, select [OK].
12) On the [[Transmission Diagnosis]], select {DTC Display}.
13) On the [[DTC Display]], select {Temporary Code} or {Memory Code}.
NOTE:
^ For details concerning the operation procedure, refer to the "help on PC application for Subaru Select Monitor".
^ For details concerning DTC, refer to "List of Diagnostic Trouble Code (DTC)".
READ CURRENT DATA
1) On the [[Main Menu]], select {Each System Check}.
2) On the [[System Selection Menu]], select {Transmission}.
3) After transmission type information pops up, select [OK].
4) On the [[Transmission Diagnosis]], select {Current Data Display & Save}.
5) On the [[Current Data Display & Save]], select {Normal Measurement}.
6) Using the scroll key, scroll the display screen up or down until the desired data is shown.
A list of the support data is shown in the following table.
NOTE:
For details concerning the operation procedure, refer to the "help on PC application for Subaru Select Monitor".