Removal and Replacement

Select Lever

REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.
3) Shift the select lever to "N" range.
4) Lift up the vehicle.
5) Remove the rear exhaust pipe and muffler.
^ Non-turbo model

^ Turbo model

6) Remove the heat shield cover.





7) Remove the cable from arm assembly.





8) Raise the claw of clamp to remove the cable.





9) Lower the vehicle.
10) Remove the grip.
11) Remove the hand brake boot cover.
12) Remove the console front panel.





13) Remove the console cover and console box.
14) Remove the indicator assembly.





15) Remove the harness clips from the bracket.
16) Remove the blind.





17) Disconnect the connectors, and then remove the four bolts to take out the select lever assembly from vehicle body.





INSTALLATION
1) Set the select lever to vehicle body.
2) Tighten the four bolts to install the select lever to vehicle body, and then connect the connector.
1) Temporarily tighten the bolt A.
2) Tighten the bolt B.
3) Tighten the bolt A.
4) Tighten the bolts C and D.





3) Install the harness clips to the bracket.
4) Install the console cover and console box.
5) Shift the select lever to "N" range.
6) Install the blind.

CAUTION:
The blind should be installed so that it is securely caught by tabs of the plate guide COMPL.





7) Install the indicator assembly.
8) Install the console front panel.
9) Install the hand brake boot cover.
10) Install the grip.
11) Lift up the vehicle.
12) Shift the range select lever to the "N" range.
13) Secure the cable to the bracket.
14) Adjust the select cable position.
15) After the completion of adjustment, confirm that the select lever operates properly at all range positions.
16) Install the heat shield cover.





17) Install the rear exhaust pipe and muffler.
^ Non-turbo model
^ Turbo model
18) Inspect the following items. When a malfunction is found in the inspection, adjust the select cable and inhibitor switch.
1) Engine starts when the select lever is in "P" and "N" range, but not in other ranges.
2) Back-up light illuminates when the select lever is in the "R" range, but not in other ranges.
3) Select lever and indicator positions are matched.