Clear Memory Mode
Clear Memory ModeOPERATION
1. ECM
1. On the [[Main Menu]] display screen, select the {Each System Check}.
2. On the [[System Selection Menu]], select the {Engine Control System}.
3. Select the [OK] after the information of engine type is displayed.
4. On the [[Engine Diagnosis]] display screen, select the {Clear Memory}.
5. When the "Done" is shown on the display screen,end the Subaru Select Monitor and turn the ignition switch to OFF.
NOTE:
- After the memory has been cleared, the idle air control solenoid valve must be initialized. To execute this procedure, turn the ignition switch to ON.Wait for 3 seconds before starting the engine.
- For detailed operation procedure, refer to the"PC application for Subaru Select Monitor".
2. BODY INTEGRATED UNIT
1. On the [[Main Menu]] display screen, select the {Each System Check}.
2. On the [[System Selection Menu]] display screen,select the {Integ. Unit}.
3. Select the [OK] after the {Integ. Unit} is displayed.
4. On the [[Integ. unit mode]] display screen, select the {Clear Memory}.
5. When the "Done" is shown on the display screen, end the Subaru Select Monitor and turn the ignition switch to OFF.
NOTE: For detailed operation procedure, refer to the "PC application for Subaru Select Monitor".