Collision Avoidance and Parking Assist Systems: Adjustments
Rearview Camera SystemADJUSTMENT
MARKER ADJUSTMENT MODE
1. Park vehicle on a level surface with wide space around the vehicle rear side.
2. Adhere tapes on the floor of the vehicle rear side as shown in the figure, as the datum point of makers.
NOTE: Use a tape of approx. 30 mm width in bright colors as a criterion.
3. While pressing key (A) and key (B) of navigation switch, turn the ignition switch to ACC to enter the test mode.
4. Touch REAR CAMERA MODE in the monitor and go to the maker adjustment mode.
CAUTION: Do not select other than REAR CAMERA MODE; the navigation system or the navigation monitor may not operate normally.
5. Touch the monitor to change maker pattern.
6. Marker pattern will be stored by turning ignition switch to OFF.
NOTE: Adjust the marker so that the marker laps over the tape or is placed outside of the tape.