Subaru Select Monitor

Subaru Select Monitor

OPERATION

READ DIAGNOSTIC TROUBLE CODE (DTC)
1) Prepare the Subaru Select Monitor kit.





2) Prepare PC with Subaru Select Monitor installed.
3) Connect USB cable to SDI (Subaru Diagnostic Interface) and PC USB port (Subaru Select Monitor dedicated port).

NOTE: Subaru Select Monitor dedicated port indicates USB port used when installing Subaru Select Monitor.

4) Connect the diagnosis cable to SDI.
5) Connect the SDI to the data link connector located in the lower portion of the instrument panel (on the driver's side).





CAUTION: Do not connect the scan tools except for Subaru Select Monitor.

6) Start a PC.
7) Turn the ignition switch to ON (engine OFF), and run the "PC application for Subaru Select Monitor".
8) On the [[Main Menu]] display screen, select the (Each System Check).
9) On the [[System Selection Menu]], select the (Brake Control).
10) Click the [OK] button after the [VDC) is displayed.
11) On the [[Brake Control Diagnosis]] display screen, select the [DTC Display).
12) Record the DTC and data.

NOTE:
^ For detailed operation procedure, refer to the "PC application for Subaru Select Monitor".
^ For details concerning DTCs, refer to "List of Diagnostic Trouble Code (DTC)".
^ DTCs are displayed up to three in detected order.

13) If VDC and Subaru Select Monitor cannot communicate, check the communication circuit.





READ CURRENT DATA
1) On the [[Main Menu]] display screen, select the (Each System Check).
2) On the [[System Selection Menu]], select the (Brake Control).
3) Click the [OK] button after the (VDC) is displayed.
4) On the [[Brake Control Diagnosis]] screen, select (Current Data Display & Save).
5) On the [[Data Display Menu]], select the data display method.
6) Using a scroll key, scroll the display screen up or down until necessary data is shown.
^ A list of the support data is shown in the following table.





NOTE: For details concerning the operation procedure, refer to the "PC application for Subaru Select Monitor".

CLEAR MEMORY MODE
1) On the [[Main Menu]] display screen, select the (Each System Check).
2) On the [[System Selection Menu]], select the (Brake Control).
3) Click the [OK] button after the (VDC) is displayed.
4) On the [[Brake Control Diagnosis]] display screen, select the (Clear Memory).
5) When the "Clear Memory?" is shown on the screen, click the [YES] button.
6) When "Done" and "Turn ignition switch to OFF" are shown on the display screen, turn the ignition switch to OFF.

NOTE: For details concerning the operation procedure, refer to the "PC application for Subaru Select Monitor".

FUNCTION CHECK





FREEZE FRAME DATA

NOTE:
^ Data stored at the time of trouble occurrence is shown on display.
^ Each time trouble occurs, the latest information is stored in the freeze frame data in memory.