Reading and Clearing Diagnostic Trouble Codes
Subaru Select MonitorOPERATION
READ DIAGNOSTIC TROUBLE CODE (DTC)
1) Prepare the Subaru Select Monitor kit.
2) Prepare PC with Subaru Select Monitor installed.
3) Connect USB cable to SDI (Subaru Diagnostic Interface) and PC USB port (Subaru Select Monitor dedicated port).
NOTE: Subaru Select Monitor dedicated port indicates USB port used when installing Subaru Select Monitor.
4) Connect the diagnosis cable to the SDI.
5) Connect the SDI to the data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION: Do not connect the scan tools except for Subaru Select Monitor.
6) Start a PC.
7) Turn the ignition switch to ON (engine OFF), and run the "PC application for Subaru Select Monitor".
8) On the [[Main Menu]] display screen, select the (Each System Check).
9) On the [[System Selection Menu]] display screen, select the (Brake Negative Pressure Pump System).
10) Click the [OK] button after the (3.6 DOHC) is displayed.
11) On the [[Negative Pressure Pump Diagnosis Menu]] display screen, select the (Diagnostic Code(s) Display).
12) Record the DTC and data.
NOTE:
^ For details concerning the operation procedure, refer to the "PC application for Subaru Select Monitor".
^ For details concerning DTCs, refer to "List of Diagnostic Trouble Code (DTC)".
READ CURRENT DATA
1) On the [[Main Menu]] display screen, select the (Each System Check).
2) On the [[System Selection Menu]] display screen, select the (Brake Negative Pressure Pump System).
3) Click the [OK] button after the (3.6 DOHC) is displayed.
4) On the [[Negative Pressure Pump Diagnosis Menu]] display screen, select the (Current Data Display & Save).
5) On the [[Data Display Menu]] screen, select the (Data Display).
6) Using a scroll key, scroll the display screen up or down until necessary data is shown.
^ A list of the support data is shown in the following table.
NOTE: For details concerning the operation procedure, refer to the "PC application for Subaru Select Monitor".
CLEAR MEMORY MODE
1) On the [[Main Menu]] display screen, select the (Each System Check).
2) On the [[System Selection Menu]] display screen, select the (Brake Negative Pressure Pump System).
3) Click the [OK] button after the (3.6 DOHC) is displayed.
4) On the [[Negative Pressure Pump Diagnosis Menu]] display screen, select the (Clear Memory).
5) When the "Clear Memory?" is shown on the screen, click the [YES] button.
6) When "Done" and "Turn ignition switch to OFF" are shown on the display screen, turn the ignition switch to OFF.
NOTE: For details concerning the operation procedure, refer to the "PC application for Subaru Select Monitor".
FUNCTION CHECK MODE
1) Connect the test mode connector located under the glove box.
2) Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
3) On the [[Main Menu]] display screen, select the (Each System Check).
4) On the [[System Selection Menu]] display screen, select the (Brake Negative Pressure Pump System).
5) Click the [OK] button after the (3.6 DOHC) is displayed.
6) On the [[Negative Pressure Pump Diagnosis Menu]] display screen, select the (Function Check Model.
7) When the "Start Function Check Mode" is shown on the screen, click the [OK] button.
8) When the "Depress the Brake Pedal 5 Times" is shown on the screen, depress the brake pedal 5 times, and click the [OK] button while brake pedal is not depressed.
9) Click the [OK] button after the (OK] is displayed.
Inspection Mode
PROCEDURE
Reproduce the malfunction occurrence condition as possible. Drive the vehicle at least ten minutes.