Crank Pulley
Crank PulleyREMOVAL
NOTE: Perform the work with the engine installed to body when replacing a single part.
1) Remove the V-belt.
2) Remove the crank pulley cover.
3) Remove the crank pulley bolt. To lock the crankshaft, use ST.
ST1 18355AAOOO PULLEY WRENCH
ST2 18334AAOOO PULLEY WRENCH PIN SET
4) Remove the crank pulley.
INSTALLATION
1) Install the crank pulley.
2) Install the crank pulley bolt. To lock the crankshaft, use ST.
ST1 18355AAOOO PULLEY WRENCH
ST2 18334AAOOO PULLEY WRENCH PIN SET
(1) Clean the crankshaft thread using compressed air.
(2) Apply engine oil to the crank pulley bolt seat and thread.
(3) Tighten the crank pulley bolts.
Tightening torque: 195 N-m (19.9 kgf-m, 143.8 ft-lb)
3) Install the crank pulley cover.
NOTE: Assemble the O-ring to crank pulley cover.
Tightening torque: 6.4 N-m (0.7 kgf-m, 4.7 ft-lb)
4) Install the V-belt.
INSPECTION
1) Check the crank pulley cover for oil and air leakage.
2) Check the crank pulley for looseness.