> display screen, select {Each System Check}.
2. On the <> display screen, select the {Integ. unit mode}.
3. On the <> display screen, select the {Current Data Display & Save}.
4. Using the scroll key, scroll the display screen up or down until the desired data is shown.
5. Display the following item and record the settings.

Required items for new registration (Except for system not equipped)

2. REGISTRATION BODY INTEGRATED UNIT (EQUIPMENT SETTING)

CAUTION: Body integrated unit is core of LAN system, and also can select the function of all vehicle system control. It is possible to control the original functions of vehicle when registrations of body integrated unit and function setting are corresponded to vehicle equipment.

If registrations and function setting are different from vehicle equipment, vehicle system does not operate normally and diagnosis cannot be performed correctly. Pay attention to following item.

- Be sure to correspond registrations and function settings to vehicle equipment.
- Do not change the settings of vehicle improperly.
- Confirm key illumination does not blink or "Factory or Market setting" of body integrated unit registrations is "Market". If "Factory or Market setting" is set to "Factory," key illumination blinks when ignition key is turned ON, to notify that the settings are unconfirmed.
- Key illumination does not blink with ignition switch turned to ON and go off with door closed.
- Be sure to register immobilizer if body integrated unit is replaced with a new part. (models with immobilizer)
- Make a registration of immobilizer when the parts related to immobilizer have been replaced. Refer to the "PC application help for Subaru Select Monitor".

1. On the <

> display screen, select {Each System Check}.
2. On the <> display screen, select the {Integ. unit mode}.
3. Click the [OK] button after the control module name {Integ. Unit} is displayed.
4. On the <> display screen, select the {ECM customizing}.
5. Change the setting with UP/DOWN key.
- List of body integrated unit registration item

NOTE: Setting is different depending on the grade of vehicle.

CAUTION:
- To perform normal operation of vehicle and diagnosis, the above settings must match the actual vehicle equipment.
- When body integrated unit is a new part or "Factory" mode, key illumination blinks to show equipment settings have not been completed. Check the detailed procedures of function setting.
- Be sure not to change Factory or Market setting except installation of new body integrated unit.

NOTE:

"Factory" mode:
- Body integrated unit has not been set yet. It can be recognized by key illumination blinking with ignition switch turned to ON.
- All replacement body integrated units are set to Factory mode. When replacing a body integrated unit, be sure to perform the registration operation.

"Market" mode:
- Each settings have been set. It can be recognized by key ring illumination coming on in concocting with room light and going off with ignition switch turned to ON.

6. Perform the Factory or Market setting. On the <> display screen of Subaru Select Monitor, select the {Factory or Market setting}.
7. Change the mode from Factory to Market.
8. Change the Subaru Select Monitor system selection to �Immobilizer� to register the immobilizer key.
9. Perform the operation according to the "PC application help for Subaru Select Monitor".
10. When key registration is completed, "Do you want to register remote engine start?" is displayed. Perform registration only for equipped models.
11. Perform the function setting (ECM customizing). Function Setting (Customize)

NOTE: For details concerning the operation procedure, refer to the "PC application help for Subaru Select Monitor".