Front Seat

Front Seat

Front Seat LH - Normal Seat (Part 1):

Front Seat LH - Normal Seat (Part 2):

Power Seat - Power Seat:

Front Seat RH:

REMOVAL

1. DRIVER'S SEAT

CAUTION: The airbag system is fitted with a backup power source. After disconnecting the battery ground cable, the airbag may deploy if you do not wait for 20 seconds before starting the service of airbag system.

1. Disconnect the ground cable from battery, and wait for 20 seconds or more before starting work.

NOTE: Remove the front and rear bolts from the slide rail of the power seat before removing the battery ground.

2. Remove the headrest.
3. Tilt the backrest forward.
4. Move the seat to the full forward position.
5. Remove the rear bolt cover at the rear end of the slide rail, and remove the two bolts.
6. Move the seat to the rearmost position.
7. Remove the two bolts at the front side of the slide rail.

8. Disconnect the connector under the seat.
- Seat belt warning light connector (Driver's seat)
- Side airbag connector
- Seat heater connector (Model with seat heater)
- Power seat connector (Model with power seats)

9. Remove the front seat from vehicle.

2. PASSENGER'S SEAT

CAUTION: Refer to "CAUTION of General Description" before starting the work.

1. Disconnect the ground cable from battery, and wait for 20 seconds or more before starting work.
2. Remove the headrest.
3. Tilt the backrest forward, and move the seat forward.
4. Remove the rear bolt cover, and then remove the rear side of slide rail.
5. Move the seat backward, remove the front bolt cover, and then remove the bolt at the front side of slide rail.
6. Disconnect all the connectors of connector holder in the backside of seat cushion.
- Harness connector of occupant detection control module
- Side airbag connector
- Seat heater connector (Models with seat heaters)

7. Remove the seat from vehicle.

INSTALLATION

Install in the reverse order of removal.

NOTE: Tighten the slide rail installing bolt gradually in two or three steps to the specified torque in the order as shown in the figure.






Tightening torque: Refer to "COMPONENT of General Description".