Radiator Main Fan

Radiator Main Fan and Fan Motor








REMOVAL
1) Set the vehicle on a lift.
2) Remove the collector cover.
3) Disconnect the ground cable from the battery.





4) Lift up the vehicle.
5) Remove the under cover.
6) Disconnect the main fan motor connector (A).





7) Remove the heat shield cover from radiator.





8) Remove the ATF hose from the hose clip of the radiator main fan motor assembly.





9) Lower the vehicle.
10) Remove the air intake duct (rear).
11) Remove the reservoir tank.
12) Remove the bolts that hold the radiator main fan motor assembly and the over flow pipe.





13) Remove the radiator main fan motor assembly from the upper side of the vehicle.

INSTALLATION
Install in the reverse order of removal.

CAUTION: Check if the radiator hose and the over flow hose are properly connected.

Tightening torque: 7.5 N-m (0.8 kgf-m, 5.5 ft-lb)





Tightening torque: 3 N-m (0.3 kgf-m, 2.2 ft-lb)





DISASSEMBLY
1) Remove the clip which holds the main fan motor connector onto the radiator main fan shroud.
2) Remove the nut which holds the radiator main fan to the main fan motor.





3) Remove the bolts which hold the main fan motor onto radiator main fan shroud.





ASSEMBLY
Assemble in the reverse order of disassembly.
Tightening torque: 4.41 N-m (0.45 kgf-m, 3.25 ft-lb)





Tightening torque: 3.4 N-m (0.3 kgf-m, 2.5 ft-lb)