Read Diagnostic Trouble Code (DTC)

Subaru Select Monitor

OPERATION

1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to the Subaru Select Monitor.
3) Connect the Subaru Select Monitor to the data link connector.
1) The data link connector is located in the lower portion of the instrument panel (on the driver's side).





2) Connect the diagnosis cable to the data link connector.

CAUTION:
Do not connect the scan tools other than the Subaru Select Monitor.

4) Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.

Read Diagnostic Trouble Code (DTC)

OPERATION

1) On the [Main Menu] display screen, select (Each System Check).
2) On the [System Selection Menu], select (Tire pressure monitor).
3) After (System Name) is displayed, select [OK].
4) On the [Tire pressure monitor diagnosis], select (Diagnostic Code(s) Display).

NOTE:
^ For details concerning the operation procedure, refer to the "PC application help for Subaru Select Monitor".
^ For details concerning DTCs, refer to List of Diagnostic Trouble Codes (DTC). List of Diagnostic Trouble Codes (TPM)
^ All DTCs detected will be displayed.
^ If a particular DTC is not properly stored in memory (due to a voltage drop of the tire air pressure monitor control module power supply, etc.) when a problem occurs, a DTC suffixed with a question mark will appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.

5) If communication is not possible between the tire pressure monitoring control module and the Subaru Select Monitor, check the communication circuit.
6) When DTC is not displayed, check the indicator circuit and communication circuit.