Subaru Select Monitor
Subaru Select MonitorOPERATION
1. Prepare the Subaru Select Monitor kit.
2. Connect the diagnosis cable to the Subaru Select Monitor.
3. Connect the Subaru Select Monitor to the data link connector.
1. The data link connector is located in the lower portion of the instrument panel (on the driver's side).
2. Connect the diagnosis cable to the data link connector.
CAUTION: Do not connect scan tools other than the Subaru Select Monitor.
4. Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
INSPECTION
1. COMMUNICATION FOR INITIALIZING IMPOSSIBLE
DETECTING CONDITION:
Defective harness connector
TROUBLE SYMPTOM: Communication is impossible between the airbag control module and the Subaru Select Monitor.
Refer to "COMMUNICATION FOR INITIALIZING IMPOSSIBLE" in the DTC of the airbag system (diag). Subaru Select Monitor
2. WITHOUT DTC
DETECTING CONDITION:
- Defective combination meter
- Open circuit of harness
TROUBLE SYMPTOM:
- Airbag warning light remains on.
- "No diagnostic Code Present" will be displayed on the Subaru Select Monitor.
NOTE:
- For detailed operation procedures, refer to "Airbag Warning Light Failure". Symptom Related Diagnostic Procedures
- When the airbag warning light is OFF and "No diagnostic Code Present" is displayed on Subaru Select Monitor, the system is operating properly.