Installation

INSTALLATION

1) Connect the inhibitor switch harness connector to the inhibitor switch.
2) Install the inhibitor switch to the transmission case.





3) Install the shifter arm and affix with a new spring pin.





4) Move the shifter arm to the neutral position.
5) Using the ST, tighten the two bolts holding the inhibitor switch.

ST 499267300 STOPPER PIN

Tightening torque: 5 N-m (0.5 kgf-m, 3.7 ft-lb)





6) Install the select cable to the shifter arm.
7) Install the plate assembly to the transmission.

Tightening torque:
T: 25 N-m (2.5 kgf-m, 18.4 ft-lb)





8) Attach the washer and snap pin to the shifter arm.





9) Install the front and center exhaust pipe. (Non-turbo model)
10) Install the center exhaust pipe. (Turbo model)
11) Lower the vehicle.
12) Inspect the inhibitor switch.