Installation

INSTALLATION

1) Aligning with the mounting hole of the rear brake back plate, temporarily tighten the rear hub unit bearing to the rear housing.

CAUTION:
^ Be careful not to damage the magnetic encoder.
^ Do not get closer the tool which charged magnetism to magnetic encoder.





2) Tighten the four bolts of the rear housing.

Tightening torque:
65 N-m (6.6 kgf-m, 47.9 ft-lb)





3) Tighten the new axle nut temporarily.

CAUTION:
Use new axle nuts.

4) Install the rear disc rotor.
5) Install the disc brake caliper to the rear housing.

Tightening torque:
66 N-m (6.7 kgf-m, 48.7 ft-lb)

6) While pressing the brake pedal, tighten the new axle nuts to the specified torque.

Tightening torque:
190 N-m (19.4 kgf-m, 140 ft-lb)

CAUTION:
^ Do not install wheel and let it touch the ground before tightening the axle nut. Failure to follow this rule may damage the axle bearing.
^ Do not overtighten the nuts as this may damage the axle bearing.

7) After tightening the axle nut, lock it securely.





8) Install the rear wheels.

Tightening torque:
100 N-m (10.2 kgf-m, 73.8 ft-lb)