Installation

INSTALLATION

1) Install the select cable to plate assembly.

Tightening torque: 18 N-m (1.8 kgf-m, 13.3 ft-lb)





2) Install the select cable to the shifter arm.
3) Install the plate assembly to transmission.

Tightening torque:
T: 25 N-m (2.5 kgf-m, 18.4 ft-lb)





4) Install the washer and snap pin to the shifter arm.





5) Install new clamp paying attention to the installing direction.





6) Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.





7) Shift the select lever to the "N" range, and adjust the select cable position.
8) Install the heat shield cover.





9) Install the front, center and rear exhaust pipes, and the muffler.
10) Install the center, rear exhaust pipes and the muffler.