Installation
INSTALLATION1) Install the joint to the transmission and secure with a spring pin.
2) Insert the gear shift lever from the room side.
NOTE:
Insert the rod and the stay, and then temporarily set them onto the transmission mount.
3) Lift up the vehicle.
4) Mount the cushion rubber on the vehicle body.
Tightening torque: 18 N-m (1.8 kgf-m, 13.3 ft-lb)
5) Using new self-locking nuts, connect the rod to the joint.
Tightening torque: 18 N-m (1.8 kgf-m, 13.3 ft-lb)
6) Using new self-locking nuts, connect the stay to the transmission bracket.
Tightening torque: 18 N-m (1.8 kgf-m, 13.3 ft-lb)
7) Install the heat shield cover.
8) Install the rear exhaust pipe and muffler.
9) Install the plate assembly to the vehicle body.
Tightening torque: 18 N-m (1.8 kgf-m, 13.3 ft-lb)
1) Set the plate assembly to the vehicle.
2) Temporarily tighten the bolt (A).
3) Tighten the bolt (B).
4) Tighten the bolt (A).
5) Tighten the bolts (C) and (D).
10) Install the harness clamp to the plate.
11) Install the boot and insulator assembly, and secure with a clamp.
12) Install the console cover and console box.
13) Install the console front panel and console boot.
14) Install the gear shift knob.
15) Check that the gear can be shifted accurately into each gear ranges.