Rear Seat

REAR SEAT

DISASSEMBLY

1. Remove the rear seat.
2. Remove the armrest hinge cover in the direction of arrow (black), and loosen the screws to remove the armrest.







NOTE: The armrests cannot be detached while the backrest assembly RH and armrest side pin positions are not aligned.







3. Remove the backrest knob. (Screw-in type) (5 door model)







4. Remove the seat back latch cover.







5. Peel the backrest cover, and remove the hog rings.







6. Remove all the hog rings which fix the backrest frame and backrest pad.
7. Remove the headrest bushing.
8. Remove the backrest pad and backrest cover from the backrest frame.
9. Disassemble the backrest assembly LH following the procedures described above.
10. Remove all the hog rings of the seat cushion,and separate the seat cushion cover and seat cushion pad.
11. Open the plastic fastener, and then remove the headrest cover from the headrest.







12. Remove the plastic fastener and hog rings, and then remove the armrest cover.







ASSEMBLY

CAUTION:
- Always use new hog rings.
- Secure the hog ring using hog ring pliers.
- Install the hog rings to the specified points
securely and make sure that no wrinkle or twisting on backrest cover.

Assemble in the reverse order of disassembly.

NOTE:
- Do not contaminate or damage the cover.
- While installing the hog rings, prevent the seat from getting wrinkled.