Overhaul
Headlight AssemblyDISASSEMBLY
1. HID HEADLIGHT BALLAST
CAUTION
- Do not perform work with wet hands.
- The HID headlight uses very high voltages for the lighting circuit. Make sure that the power is turned OFF before working.
- Do not leave the headlight without the ballast for a long time. Dust, moisture, etc. entering the headlight may affect its performance.
1. Disconnect the ground cable from battery.
2. Remove the headlight assembly.
3. Remove the back cover.
4. Disconnect the harness connector.
5. Remove the harness connector and screws to pull out the ballast.
6. Remove the harness connector and screws on the back to remove the headlight ballast.
ASSEMBLY
1. HID HEADLIGHT BALLAST
CAUTION:
- When installing the ballast cover, be sure to install the gasket.
- After installing the ballast to the vehicle, be sure to perform beam adjustment.
Install in the reverse order of removal.
Tightening torque: 1.3 N.m (0.13 kgf.m, 0.96 ft.lb)
NOTE: Adjust the projector lens to near the center of the extension opening before installing the ballast. This makes the beam adjustment work easier.