Rear Combination Light Assembly

Rear Combination Light Assembly

REMOVAL

1. 4 DOOR MODEL
1. Disconnect the ground cable from battery.
2. Remove the trunk room side trim.
3. Remove the harness connector and four nuts, and remove the rear combination light.






2. 5 DOOR MODEL
1. Disconnect the ground cable from the battery.
2. Remove the two bolts, and then detach the rear combination light by pulling it to the rear side of vehicle.






3. Disconnect the harness connector and rear combination light.

INSTALLATION

Install in the reverse order of removal.

Tightening torque: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)