Installation

INSTALLATION

1) Place the disc cover between housing and front hub unit, and tighten the four bolts.

Tightening torque:
65 N-m (6.6 kgf-m, 47.9 ft-lb)





2) Install the front drive shaft.
3) Tighten the axle nut temporarily.
4) Install the disc rotor to hub.
5) Install the disc brake caliper on the housing.

Tightening torque:
80 N-m (8.2 kgf-m, 59 ft-lb)

6) While depressing the brake pedal, tighten a new axle nut to the specified torque and lock it securely.

Tightening torque:
220 N-m (22.4 kgf-m, 162.3 ft-lb)

CAUTION:
^ Do not install wheel and let it touch the ground before tightening the axle nut. Failure to follow this rule may damage the axle bearing.
^ Do not overtighten the nuts as this may damage the axle bearing.

7) After tightening the axle nut, lock it securely.





8) Install the wheel.

Tightening torque:
100 N-m (10.2 kgf-m, 73.8 ft-lb)