With Manufacturer's Scan Tool

Clear Memory Mode

OPERATION

NOTE: When Clear Memory Mode is performed in OBD mode of Subaru Select Monitor, only DTCs are cleared.

SUBARU SELECT MONITOR (NORMAL MODE)
1. On [[Main Menu]] display, select {Each System Check}.
2. On [[System Selection Menu]] display, select {Engine Control System}.
3. Click the [OK] button after the information of engine type has been displayed.
4. On [[Engine Diagnosis]] display, select {Clearing Memory}.
5. When the "Clear Memory?" is shown on the screen, click the [YES] button.
6. When "Done" and "Turn off the ignition switch." are shown on the display screen, turn the ignition switch to OFF.

NOTE:
- Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.
- For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".

SUBARU SELECT MONITOR (OBD MODE)
1. On [[Main Menu]] display, select {Each System Check}.
2. On [[System Selection Menu]] display, select {Engine Control System}.
3. Click the [OK] button after the information of engine type has been displayed.
4. On [[Engine Diagnosis]] display, select {OBD System}.
5. On [[OBD Menu]] display, select {Clear Diagnostic Code}.
6. When the "Clear Diagnostic Code?" is shown on the screen, click the [Yes] button.
7. When "Done" and "Turn off the ignition switch." are shown on the display screen, turn the ignition switch to OFF.

NOTE:
- Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.
- For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".