Reduction Driven Gear

Reduction Driven Gear

REMOVAL

1) Remove the transmission assembly from vehicle body.
2) Remove the rear wheel speed sensor, and separate the extension case from transmission case.
3) Set the range select lever to the "P" range.
4) Lift the crimped section, and then remove the lock nut.





5) Using the ST1 and ST2, extract the reduction driven gear.

ST1 499737000 PULLER
ST2 899524100 PULLER SET





INSTALLATION

1) Set the range select lever to the "P" range.
2) Using a plastic hammer, install the reduction driven gear assembly and the new washer, and tighten the new drive pinion lock nut.

Tightening torque:
100 N-m (10.2 kgf-m, 73.8 ft-lb)





3) After tightening, stake the lock nut securely.
4) Join the transmission case and the extension case, and then install the rear vehicle speed sensor.
5) Install the transmission assembly to the vehicle.

DISASSEMBLY

1) Remove the snap ring from reduction driven gear.





2) Remove the ball bearing from reduction driven gear using ST.

ST 498077600 REMOVER





3) Remove the gear inner groove snap ring from the reduction driven gear.

ASSEMBLY

1) Install the snap ring to the gear inner grove on the reduction driven gear.
2) Install the new ball bearing to reduction driven gear using press.





3) Install the snap ring to reduction driven gear.





INSPECTION

Make sure the ball bearing and gear is not deformed or damaged.