With ABS

Read Diagnostic Trouble Code (DTC)

OPERATION
1) On [Main Menu] display, select {Each System Check}.
2) On [System Selection Menu] display, select {Brake Control System}.
3) Click the [OK] button after the {ABS} is displayed.
4) On [Brake Control Diagnosis] display, select {Diagnostic Code(s) Display}.
5) Record the DTC and data.

NOTE:
- For details concerning DTCs, refer to "List of Diagnostic Trouble Code (DTC)".
- Up to 3 DTCs are displayed in the order of detection.
- If a particular DTC is not stored in memory properly at the occurrence of problem (due to a drop in ABSCM&H/U power supply etc.), the DTC suffixed with a question mark "?" is displayed on Subaru Select Monitor display screen. This shows it may be an unreliable reading.
- If "No diagnostic Code Present" is displayed, check combination meter or harness.
- When the ABS warning light is OFF and "No diagnostic Code Present" is displayed, the system is operating properly.





Inspection Mode

PROCEDURE
Reproduce the malfunction occurrence condition as much as possible.

Drive the vehicle at a speed of 40 km/h (25 MPH) or more for at least one minute.

Clear Memory Mode

OPERATION
1) On [Main Menu] display, select {Each System Check}.
2) On [System Selection Menu] display, select {Brake Control System}.
3) Click the [OK] button after the {ABS} is displayed.
4) On [Brake Control Diagnosis] display, select {Clearing Memory}.
5) When the "Clear Memory?" is shown on the screen, click the [YES] button.
6) When "Done" and "Turn off the ignition switch." are shown on the display screen, turn the ignition switch to OFF.