Rear Oxygen Sensor
Rear Oxygen SensorREMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Lift up the vehicle.
4. Remove the transmission under cover.
5. Disconnect the connector from the rear oxygen sensor, and remove the clip (A) holding the rear oxygen sensor harness.
6. Apply spray-type lubricant to the threaded portion of rear oxygen sensor, and leave it for one minute or more.
7. Remove the rear oxygen sensor.
CAUTION: When removing the rear oxygen sensor, wait until exhaust pipe cools, otherwise it will damage the exhaust pipe.
INSTALLATION
CAUTION: If lubricant is spilt onto the exhaust pipe, wipe it off completely with cloth to avoid emission of smoke or causing a fire.
1. Before installing rear oxygen sensor, apply the anti-seize compound only to the threaded portion of rear oxygen sensor to make the next removal easier.
CAUTION: Never apply anti-seize compound to the protector of rear oxygen sensor.
Anti-seize compound:
NEVER-SEEZ NSN, JET LUBE SS-30 or equivalent
2. Install the rear oxygen sensor.
3. Connect the connector to the rear oxygen sensor, and hold the rear oxygen sensor harness with the clip (A).
4. Install the transmission under cover.
5. Lower the vehicle.
6. Connect the ground cable to battery.
