Adjustment
ADJUSTMENT1) Set the vehicle on a lift.
2) Remove the under cover.
3) Remove the rear exhaust pipe and muffler.
4) Remove the heat shield cover.
5) Remove the crossmember.
6) Remove the snap pin and washer, and separate the reverse check cable from the reverse check lever.
7) Move the transmission to the right side, and remove the stay bolts and the reverse check cable.
NOTE:
If the transmission is not moved aside, the stay bolts may contact the body and cause damage.
8) With the cable pulled (the slider lowered), adjust the length from the cable plate end to the reverse check cable to 84 mm (3.31 in), and tighten the lock nut.
Tightening torque:
6 Nm (0.6 kgf-m, 4.4 ft-lb)
9) Move the transmission to the right side of the vehicle and install the stay.
Tightening torque:
T: 32 Nm (3.3 kgf-m, 23.6 ft-lb)
10) Install the crossmember.
11) Install the heat shield cover.
12) Install the rear exhaust pipe and muffler.
13) Install the reverse check cable, washer and snap pin to the reverse check lever.
NOTE:
Be careful to install the snap pin in the proper direction.
14) Install the under cover.