Installation

INSTALLATION

1) Insert the reverse check cable into the inner boot hole from underside of the vehicle.
2) Insert the reverse check cable into the gear shift lever assembly, and secure it with the band clip.

NOTE:
^ Cut the excess band clip.
^ Make sure that the reverse check cable is inserted into the gearshift lever with no gaps.





3) Use the spring pin to secure the end of the slider and reverse check cable.

NOTE:
Apply grease to the moving part of slider.





4) With the cable pulled (the slider is lowered), adjust the distance between the edge of cable plate and the reverse check cable to 84 mm (3.31 in), and tighten the lock nut.

Tightening torque:
6 Nm (0.6 kgf-m, 4.4 ft-lb)





5) Move the transmission to the right side, and install the stay.

Tightening torque:
T: 32 Nm (3.3 kgf-m, 23.6 ft-lb)





6) Install the reverse check cable, washer and snap pin to the reverse check lever.

NOTE:
Make sure to point the snap pin in an appropriate direction.





7) Secure the reverse check cable to the stay clip.

NOTE:
Install the reverse check cable on top of the stay.





8) Install the heat shield cover.





9) Install the rear exhaust pipe and muffler.
10) Install the boot and insulator assembly, and secure with a clamp.





11) Install the console box.