Removal

MT Gear Shift Lever

REMOVAL

1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Remove the gear shift knob.
4) Remove the console box front.
5) Remove the clamp.





6) Remove the boot and insulator assembly.





7) Remove the harness clamp from the plate assembly.





8) Remove the plate assembly from the body.





9) Lift up the vehicle.
10) Remove the under cover.
11) Remove the rear exhaust pipe and muffler.
12) Remove the heat shield cover.





13) Remove the crossmember.
14) Remove the snap pin and washer, and remove the reverse check cable from the reverse check lever.





15) Move the transmission to the right side, and remove the joint COMPL, stay bolts and reverse check cable.

NOTE:
If the transmission is not moved aside, the joint COMPL and stay bolts may contact the body and cause damage.





16) Remove the cushion rubber from the body.





17) Lower the vehicle.
18) Remove the gear shift lever.